close
close

How To Install Hardie Board Panels. There are four methods for the vertical joint treatment in james hardie stucco panel siding. Before you begin your siding project read the instruction manual completely and thoroughly.

Image result for pre finished hardie lap siding House
Image result for pre finished hardie lap siding House from www.pinterest.com

As a homeowner, you will work with a contractor, who will facilitate the installation of your hardie® siding, trim, soffit, wrap and flashing products (including products with colorplus® technology). The material contained herein provides installation guidelines for the hardie® architectural panel system by james hardie. Installation manual for reveal panel system page 2.

To Prepare For Your Siding Installation Project, You’ll Need To Do These Three Things.

Hardie boards should be at least 6″ above the grade level of the house. First, cover the walls with foam or plywood. With the rising popularity of architectural panels in edmonton, designers and contractors are often choosing hardie panel with easy trim as a modern design option that saves homeowners money (check out our blog post on contemporary design to learn more about hardie panel and easy trim).

Place All Nails 3/8 Inch From The Hardiepanel.

Installation manual for reveal panel system page 2. The corners should be at least ¼” thicker than two stacked pieces of siding. To begin installing the hardie boards, place the trim in the corners of the wall.

Install The Panels In Moderate Contact.

We have dozens of installation specialists. You will be working with a contractor or builder to install james hardie brand products. The material contained herein provides installation guidelines for the hardie® architectural panel system by james hardie.

Before You Begin Your Siding Project Read The Instruction Manual Completely And Thoroughly.

Drive the nails to be just flush with the surface of the panel, but not so deep that the nails dimple the panel surface. There are four methods for the vertical joint treatment in james hardie stucco panel siding. Here are the steps to take in order to ensure a smooth process.

Start Installing Your Boards A Quarter Inch Above The Floor, Tub, Or Shower Board And Caulk Accordingly.

For most recent version visit hardieinstallation.com. Fasten cement board with specified nails or screws, a maximum of 8” on center at all supports. Keep fasteners ⅜” from board edges and 2” in from sheet corners.


0 Comments

Leave a Reply

Avatar placeholder

Your email address will not be published.